Candle with remote control and Arduino Pro Mini
Here I present another project based on a addressable LEDs strip, based on WS2812b leds.
It consists of an 'electronic' candle, which lets you select set colors, adjust the intensity, and have different effects like rainbow, fade and fire. The project arose from the purchase of an IKEA lantern model BORBY ... the idea was to replace a candle of considerable size, for something more ... modern.
Kaleidoscope with Arduino and RGB LED strips
I present a new Arduino project: a Kaleidoscope (or something similar), with a list of the simplest materials.
You can see the result in the video. It can be used as decoration in a living room or as decoration for the baby's crib. The baby will be surprised ... Very relaxing if it accompanied with Chill out music .
Thanks to the advent of addressable LED strips, is extremely simple (and cheap) to create projects with multiple RGB LEDs.
These strips contain small RGB leds. Each led is accompanied by a WS2812 circuit capable of controlling an RGB LED with 256 levels for each color.
In the previous post (Christmas Tree shield for Arduino) I talk about the benefits of these chips
The strips have three connections +5 V, GND and data input (DI). Be careful because in the strips is indicated the data flow, the data must enter through DI and exit through DO (on the opposite side). To connect a strip piece with another, connect the DO of the first with the second DI.
The strips can be cut with simple scissors through the mark
Adafruit (2) addressable led strip (2) Arduino (11) Arduino Pro Mini (2) Christmas (1) Control Remoto (1) DHT11 (1) DHT22 (1) DS1307 (1) DS3231 (1) FFT (2) led pixel (1) Led strip (2) Lights (5) Microphone (1) MOC3041 (1) MP3 (2) MP3 Player (2) Neopixel (1) Optocouplers (1) Power (1) Remote controller (1) RGB Led (5) SD (2) Triac (1) TSOP1738 (3) ULN2003 (1) vs1002 (2) vs1003 (2) vs1053 (2) WS2811 (3) WS2812 (4) WS2812b (3) Xmas (1)
Arduino Mp3 Payer II (code) > I present this new Arduino project: A full MP3 player based on Arduino . As you can see in...
Kaleidoscope with Arduino and RGB LED strips I present a new Arduino project : a Kaleidoscope (or something similar), with a list o...
Taking advantage of the previous post, we are going to add an IR receiver to the circuit so that we can vary the color and brightness of the...
< Arduino MP3 Player I (circuit) The SD structure In this post I'll try to explain a little the code of our 'Jukebox...
Christmas comes, and nothing more typical than riding a Christmas tree to give a bit of atmosphere. They come in many types, but this is ...
Candle with remote control and Arduino Pro Mini Here I present another project based on a addressable LEDs strip, based on WS...
<< Arduino light organ (I) - Introduction Arduino light organ (III) - Power stage >> Obtaining the signal As ...
Arduino light organ (II) - The circuit >> Introduction Those who have a few years as I, recall that back in the 1980s, in any di...
<< Arduino light organ (II)- The circuit WARNING: In this part is used mains voltage, which can carry risks. If you do not have en...
Well, let's start with a 'dumb' for begin. The idea is that a RGB LED simulate the effect 'Rainbow' as some by thems...
Powered by Blogger.